July 1, 20214 yr 1 hour ago, UncleBuck said: Once my brisket puts on the paper, I'm wide open on the intake and cranking the heat up. What pit? What does your pit get to with the vents wide open?
July 1, 20214 yr Just now, dcbc said: What pit? What does your pit get to with the vents wide open? I use a 22" WSM these days. After wrapping I go wide open until I get to 290ish, opening the door if I have to, then hold it there. But even back in the stick days I'd throw an extra log/extra shovel of coals and go wide open on the firebox vent until it felt right.
July 1, 20214 yr 3 minutes ago, UncleBuck said: I use a 22" WSM these days. After wrapping I go wide open until I get to 290ish, opening the door if I have to, then hold it there. But even back in the stick days I'd throw an extra log/extra shovel of coals and go wide open on the firebox vent until it felt right. Does this cut down your total cooking time? If so, by how much?
July 1, 20214 yr 4 minutes ago, UncleBuck said: I use a 22" WSM these days. After wrapping I go wide open until I get to 290ish, opening the door if I have to, then hold it there. But even back in the stick days I'd throw an extra log/extra shovel of coals and go wide open on the firebox vent until it felt right. Okay. Me too. If it's holding at 190, I'm assuming you've got water or something else in the pan, correct? I push mine a little bit once it's wrapped, but I've had better luck keeping it below 260F at that point. Edited July 1, 20214 yr by dcbc
July 1, 20214 yr Just now, Texas St. Armadillos said: Does this cut down your total cooking time? If so, by how much? Yes. Not really sure how much time, just know it does since I'm cooking hotter. Would be cool to run an experiment.
July 1, 20214 yr 4 minutes ago, dcbc said: Okay. Me too. If it's holding at 190, I'm assuming you've got water or something else in the pan, correct? Have my pan filled with sand and covered in thick foil. Can take a lot to get up to 290, just depends on the conditions I guess. A temp controller fan would probably help. I just go wide open and leave the door open to get the fire hot. Shut the door, see how much it rises. Repeat. Can also get it hot just leaving the lid completely off a few minutes. Edited July 1, 20214 yr by UncleBuck
July 1, 20214 yr 5 minutes ago, UncleBuck said: Have my pan filled with sand and covered in thick foil. Can take a lot to get up to 290, just depends on the conditions I guess. A temp controller fan would probably help. I just go wide open and leave the door open to get the fire hot. Shut the door, see how much it rises. Repeat. Can also get it hot just leaving the lid completely off a few minutes. Cool. I have two nested clay pot bases in mine (foiled). So probably similar.
July 1, 20214 yr 2 minutes ago, dcbc said: Cool. I have two nested clay pot bases in mine (foiled). So probably similar. Probably a lot easier to assemble that way. Heavy lifting the body onto the bottom with all of that sand
July 1, 20214 yr 7 minutes ago, UncleBuck said: Probably a lot easier to assemble that way. Heavy lifting the body onto the bottom with all of that sand I'd just take the bowl out to foil it and set it in there after the body's on in that case. It's noticeably heavier with the clay bases, but not unmanageable. Gets me thinking about adding handles sometimes though.
July 3, 20214 yr On 6/29/2021 at 9:39 PM, Both Tacos said: You killed my father with a scalloped knife...prepare to die. fify
July 5, 20214 yr Popular Post Wagyu Brisket, Smoked Chicken and Sausage.Happy Fourth!Sent from my iPhone using Tapatalk
July 5, 20214 yr Man, I’m on the way over. Looking forward to tacos in the morning and sandwiches for lunch too.
August 4, 20214 yr Trying something new. Smoking a full packer. On the second one split the point and flat. Trying burnt ends. Hope it turns out worth a damn.
August 4, 20214 yr On 7/1/2021 at 1:11 PM, UncleBuck said: I use a 22" WSM these days. After wrapping I go wide open until I get to 290ish, opening the door if I have to, then hold it there. But even back in the stick days I'd throw an extra log/extra shovel of coals and go wide open on the firebox vent until it felt right. Shit, I’m over 305F for the entire cook on my WSM
August 4, 20214 yr 2 hours ago, Cajun said: Shit, I’m over 305F for the entire cook on my WSM Man, I just can't bring myself to do an entire hot and fast cook on a brisket. Takes some balls!
August 4, 20214 yr 38 minutes ago, UncleBuck said: Man, I just can't bring myself to do an entire hot and fast cook on a brisket. Takes some balls! I was 225 for decades. Now I go 285-300 and I'll never go back. No change in quality, and much quicker. I can start a 13-lber in the morning and easily be ready for dinner by 6 or 7. Edit: I should probably specify this is on an offset stick-burner, just for the record... Edited August 4, 20214 yr by utee94
August 4, 20214 yr Since I am relatively new to the game. At what temperature do I pull the point to slice into burnt ends? How long do they go back in once sliced? They are for dinner tonight so gonna hold in a cooler until closer to dinner time. At 187 now after 5.5 hours.
August 4, 20214 yr Since I am relatively new to the game. At what temperature do I pull the point to slice into burnt ends? How long do they go back in once sliced? They are for dinner tonight so gonna hold in a cooler until closer to dinner time. At 187 now after 5.5 hours.You should go by feel. When poking the point with a thermometer it should slide in with absolutely NO resistance. Temp will probably be around 200. You take it out, cube it into 1" squares, place in pan with bbq sauce, stir and place back into the smoker for about 30 minutes. Enough for the sauce to set and the exposed sides where you cut to firm up. Then go place in a cooler.I've never put it in a cooler and then make it into burnt ends later.
August 5, 20214 yr 19 hours ago, CoachTex said: Slices were a little dry due to no point. Burnt ends were on point. Looks awesome man. Nice job!
August 5, 20214 yr Slices were a little dry due to no point. Burnt ends were on point.Looks good. Just so you know, you don't have to cook them separately when you want to make burnt ends. Cook the full packer and when the flat is done, separate the point from it. If I'm going that route, I will usually trim the fat between the two before smoking so it is easier to handle and come apart when it is hot.
August 6, 20214 yr 1 hour ago, Both Tacos said: 23 hours ago, CoachTex said: Slices were a little dry due to no point. Burnt ends were on point. Looks good. Just so you know, you don't have to cook them separately when you want to make burnt ends. Cook the full packer and when the flat is done, separate the point from it. If I'm going that route, I will usually trim the fat between the two before smoking so it is easier to handle and come apart when it is hot. Yeah I thought of that as I was cutting up the flat.
August 8, 20214 yr Can’t read through all of this, but have a brisket that’s been on the smoker for about 14 hours. Internal temp of 175. When to pull it? Wrap immediately or wait and then wrap? If I put it in a good cooler, how long can I rest it, as dinner is still 7 hours away?
August 8, 20214 yr 15 minutes ago, Sbbruin said: Can’t read through all of this, but have a brisket that’s been on the smoker for about 14 hours. Internal temp of 175. When to pull it? Wrap immediately or wait and then wrap? If I put it in a good cooler, how long can I rest it, as dinner is still 7 hours away? Keep going til you hit about 202-204, needs to probe like butter. When it is done you can keep it in a cooler, maybe wrapped in a towel, for as long as you need. you may try wrapping it in butcher paper or foil to help it get through the stall faster. Edited August 8, 20214 yr by Etexhorn13
August 8, 20214 yr 5 minutes ago, Etexhorn13 said: Keep going til you hit about 202-204, needs to probe like butter. When it is done you can keep it in a cooler, maybe wrapped in a towel, for as long as you need. you may try wrapping it in butcher paper or foil to help it get through the stall faster. I think it’s through the stall. 200+ seems pretty high. I was thinking like 185-190?
August 8, 20214 yr 14 minutes ago, Sbbruin said: I think it’s through the stall. 200+ seems pretty high. I was thinking like 185-190? Nope, at least 200 to get it to probe like butter. You can wrap in foil to get through the stall, but it might impact the bark. What temp is your pit and how big is this thing? 14 hrs isn't excessive, but close.
August 8, 20214 yr I think it’s through the stall. 200+ seems pretty high. I was thinking like 185-190?Couldn’t tell you the last time I had one pull sub-200. Def keep going till true butter probe. Prob 202-206.If you’re going to pull and hold it, remember to rest it unwrapped on counter 1 hour before slicing to eat. Holding is not resting.
August 8, 20214 yr Just now, Lurch said: Couldn’t tell you the last time I had one pull sub-200. Def keep going till true butter probe. Prob 202-206. If you’re going to pull and hold it, remember to rest it unwrapped on counter 1 hour before slicing to eat. Holding is not resting. So wrap immediately, throw it in a cooler, than pull it from the cool and let it rest unwrapped for an hour?
August 8, 20214 yr People that pull at 180-195 often think their brisket is tough and dry because it's overcooked. It's counter-intuitive but it's actually undercooked. Like Lurch, I can't tell you the last time I had a brisket that was finished, under 200. It's happened in the past and I always go by feel, but these days I don't even bother starting to probe until it's 199, and usually 203-205 is when it's right.
August 8, 20214 yr So wrap immediately, throw it in a cooler, than pull it from the cool and let it rest unwrapped for an hour?1. Wait until it’s done2. Wrap in foil, then a towel, then throw that into cooler3. 60-90 mins before eating, take it out and fully unwrap it. Let it sit on counter.4. After 60-90 you can slice
August 8, 20214 yr Shit, I need someone (or someoneS) to come over & help me work this smoker rig of mine & figure it out. I do ribs well enough, but for briskets I seem to have a blind spot. I'll provide the meat, some beers, radio, constant shade & a fan - you bring the thermometer of your choice. Who wants to hang?
August 8, 20214 yr 57 minutes ago, ROFL BOX said: Shit, I need someone (or someoneS) to come over & help me work this smoker rig of mine & figure it out. I do ribs well enough, but for briskets I seem to have a blind spot. I'll provide the meat, some beers, radio, constant shade & a fan - you bring the thermometer of your choice. Who wants to hang? Define "some beers." Also, what kind of cooker are we talking?
August 8, 20214 yr If you are going to keep it wrapped and stored in a cooler for an hour or two post-smoke shouldn’t you let it come down to around 160-170 degrees first? I have wrapped it in paper and towels right after taking it off the smoker (at around 204 or so) and put it in a cooler and it kept cooking.
August 8, 20214 yr Should be fine. You’re no longer adding heat so I’m not sure that’s technically “cooking”
August 8, 20214 yr Thermapen went into it like buttah. Hopeful. Bark not quite where I’d want it, but hoping the meat makes up for it. About my 4th brisket, and just haven’t quite hit it. I’m thinking this one might be it (by my simple standards).
August 8, 20214 yr 4 hours ago, Sbbruin said: I think it’s through the stall. 200+ seems pretty high. I was thinking like 185-190?
August 8, 20214 yr 16 minutes ago, Sbbruin said: Pulled at 201. Now wrapped and in the cooler. What are you cooking on? And what fuel/wood? That looks…interesting
August 8, 20214 yr 3 minutes ago, Sbbruin said: Turkey pan in the oven with liquid smoke. There better be french fucking dressing involved, sir.
August 8, 20214 yr Define "some beers." Also, what kind of cooker are we talking?Prob. (1) 18 caser per person oughta get it done, depends on how many show & what your motor oil of choice is Sent from my SM-G950U1 using Tapatalk
August 8, 20214 yr 12 minutes ago, ROFL BOX said: Prob. (1) 18 caser per person oughta get it done, depends on how many show & what your motor oil of choice is Sent from my SM-G950U1 using Tapatalk Had my fingers crossed for a WSM, but that looks like real work.
August 8, 20214 yr 37 minutes ago, Sbbruin said: Turkey pan in the oven with liquid smoke. This is the way.
August 9, 20214 yr Prob. (1) 18 caser per person oughta get it done, depends on how many show & what your motor oil of choice is Sent from my SM-G950U1 using TapatalkMirror image of my smoker.
August 9, 20214 yr 12 minutes ago, Sbbruin said: Mirror image of my smoker. Both are linked to wiki's sadness images. Clean up that shit, sell it, and get a WSM.
August 9, 20214 yr We have WAAAY more than we’ll eat tonight. Is it best to slice and then vacuum seal slices, or vacuum seal a big hunk unsliced?
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.